Pier and Surf Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
929 Posts
Discussion Starter · #1 ·
Was just reading this on another site ....

." The nickle coating flakes off of the brass line roller leaving behind tiny razor sharp edges that slowly and microscopically destroys your line. You may wanna check your gear."sol
 

·
Banned
Joined
·
2,922 Posts
So, I'm guessing the solution to this is to remove the rest of the nickle-plating and then to polish the brass underneath ?

Of course, new parts could be gotten, while available, but would still be subject to the same problem, down the road.
 
1 - 4 of 4 Posts
Top