Pier and Surf Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
My bail is falling down too low and hitting the handle.
I can see there is a "bail stop"
I ordered a new one, but I have no clue how to remove the old one.
Not sure if it is just pressed in??

Any suggestions?
 

·
Registered
Joined
·
124 Posts
My bail is falling down too low and hitting the handle.
I can see there is a "bail stop"
I ordered a new one, but I have no clue how to remove the old one.
Not sure if it is just pressed in??

Any suggestions?
Is it possible you rotated the bail too far past the stop when putting it back together? That was easy to do with other Mitchell reels I have owned
 

·
Registered
Joined
·
7 Posts
Discussion Starter #5
There is a bail stop, it is worn down.
I bought a new part.

Have no clue how to change it. It is a nylon cylinder. Old one is pressed? Glued in???
 
1 - 5 of 5 Posts
Top