Pier and Surf Forum banner
1 - 2 of 2 Posts

· Registered
144 Posts
Discussion Starter · #1 ·
I am seeking some advice a fixing a somewhat busted guide. The inner black 'washer' dislodged from the round metal 'thingee' - see below.

Hand Fashion accessory Electric blue

As you can probably tell, my very technical references to the parts above suggests I have little knowledge or experience on guide repair/replacement. Is it possible to ascertain the size of the missing 'washer' and buy the missing the piece or cheaply purchase a kit various size 'washers'? If so, what is the name of the piece I am looking for? Or would I likely just need to replace the entire guide? The rod is an Okuma TU-150 and the guide is the 3rd from the top.

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.