Pier and Surf Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
I am gonna try to yak out some larger bait, likely chunk of ray, from the beach for biters. Will be using a TLD-50. I have never done this before, as I normally cast a pulley rig with a heaver. Understanding that it depends on several factors (amount and type of line out, amount of current, size of bait, etc.), how much weight/what sinker type do you experienced yakkers use?

Thanks,

Shunt
 

·
Registered
Joined
·
4,346 Posts
I think it would depend on if you're using mono or braid, and the size of your bait. I was yakking tuna heads out with two 28oz deep drop weights clipped on. Dunno if that was overkill, but it stayed in place, and I was using 50 lb mono at the time. Braid cuts down on the drag on the line from the water considerably, so you could probably get away with lighter weights.
 

·
Registered
Joined
·
51 Posts
I have often used a fish finder rig above the last swivel. Take a 3 hole common brick w/ 10 to 15# mono, depending on current and waves, tied through a hole in the brick attached to fishfinder. She can still move off with the bait and when you get hooked up that brick's sharp edge of the hole chaffs right through that mono and you are weight free.
It also comes free when you are reeling inthe bait from way out yonder.
beagle
 

·
Registered
Joined
·
390 Posts
All I use now for yak baits are the King rig Anchors
 

·
Registered
Joined
·
20 Posts
Last year at OBX I was yakking out clams and bunker heads on both hi/lo as well as fishfinder rigs.
I was using 12 to 15 oz pyramid sinkers and boy was my arm sore by the time I reeled those babys in.
They seemed to have held bottom well for the most part
 
1 - 7 of 7 Posts
Top