Pier and Surf Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a dumb question. I came to have a Penn Jigmaster 500L reel. The stainless steel side brace that sits in front of the take up spool has three holes apprx. .187 x .250, one left, one right, and one center. Intuitively, I wanted to thread the line through the center hole to tie onto the reel. When I went to wind the line on, it wanted to wrap it all up in the center. I then realized that the line must go over the brace, but I still am not sure. Any help? :confused:
 

·
Registered
Joined
·
823 Posts
YOU ARE CORRECT AND YOU MUST LEVEL THE LINE YOURSELF. this is not a level line reeland the line must go over the brace not thru it. good luck
 
1 - 2 of 2 Posts
Top