On the water
Regional Reports
Vendor Member Section
Etc.
Archive
Latest Posts
-
Open ForumHey out there. Looking to build a 16 rod fishing rod holder. One that I can put in the corner of room. I've seen these round ones and they would work fine. Need measurements and ideas.
- 0
- 97
-
Maryland/ DelawareGood Afternoon Folks, and Happy New Year! I've been fishing and catching some pretty good-sized blue catfish. In the first picture, is one that I caught Saturday and it was more than 30 inches long. I'm thankful for the two fisherman that assisted me getting it into my large net. The next is...
- 6
- 263
-
Open ForumHi folks, I'm considering magging a Surfmaster reel. It has the aluminum spool. However, the outer face of the spool that would face the magnet(s) has slightly raised radial ribs. Will these ribs have an adverse effect regarding the influence of the magnet(s) on the spool ?I have yet to open any...
- 41
- 908
-
Open ForumBought one of the older Penn battle 4000 reels. Has 6 +1 bearings. The battle 2 and 3 have 5+1, are they getting cheap on the 2 and 3 battles?
- 4
- 497